Silicone mold is the production of handicrafts for the mold plastic, silicone is characterized by high temperature, corrosion resistance, tear resistance, simulation fine high, with a wind, intelligent wear was pushed to the forefront of the trend, silicone products favored by the market, Mold Making Silicone Rubber A variety of products are delicate silicone feel as ID, is widely used.
Silicone is a thermosetting material, therefore, silicone molds are generally pressure molding, rubber mold in the processing of products, is the raw rubber into the rubber mold cavity, and then mold heat insulation molding. Silicone mold, also known as plastic mold or injection mold, plastic is a thermoplastic material, the general use of injection molding mold, silicone mold in the processing of products, it is the melting of plastic raw materials to a certain pressure, speed, temperature injection mold cavity In, and then insulation, packing, cooling molding. Mold Making Silicone Rubber Both methods of processing products are obviously not the same. Silicone mold is heated in the mold, the silicone mold is heated in the barrel. Silicone mold is easy to go Phi front, generally about 100M from the edge of the product (try the size of the product) to do pull the Phi Phi position. The design does not use the water to use the heat pipe, there is no top out of the body, upside down generally do inserts off (because the plastic material is very soft, feels very comfortable) if the reverse buckle can do core pulling mechanism, but also auxiliary role , Mainly taking into account the good processing, easy to use manual products. Usually silicone mold inverted structure is not allowed, Mold Making Silicone Rubber but the silicone mold depends on the processing of different materials, can be a perfect stripping.
General silicone mold directly after the production by hand stripping, if the production of direct front with a direct hand, some molds have to do a special batch of front. Silicone mold on the A board B board with the entrance is a set of mold. But the silicone mold is relatively complex structure, mold manufacturing cycle is longer, Mold Making Silicone Rubber the mold cost is high, and now for a variety of reasons, there are some customers choose silicone mold to open silicone products, injection molding with granular silicone material.
Silicone mold is the production of handicrafts for the mold plastic, silicone is characterized by high temperature, corrosion resistance, tear resistance, simulation fine high, Mold Making Silicone Rubber is to do all kinds of crafts mold.
Silicone mold mainly used in toys, gifts, fine pattern of products for the package mold, pouring mold products, glass technology, lighting, candles, characters copy production mold, Mold Making Silicone Rubber large pieces of products, open film, relief, Craft gift production mold, soles model, perfusion mold, sand casting.